pAU-1 power amplifier unit kit

What you're looking at is a brand new 25 PAU-1 amplifier card for a Seeburg KD200 or L100. This is the best thing you can ever find. A lot of hours have been invested and a large sum of money to make this table the last one you'll ever need. All components are brand new, including all capacitors, resistors and ceramic pipe hoses, and they are all of the highest quality. This is an exact replacement card, which does not require changes to your machine: just install a good set of valves, disconnect the old board and reconnect this. Each single card has been tested in a real Jukebox before shipment. The short-circuit and/or damaged valves can damage this card and the transformer, so before installing the board you need to make sure to install a set of tested valves and in good condition. The original material of the board, welding and traces made these machines very unreliable. One of the other problems of the original cards is the tendency to create short circuits between fingers and traces, with the risk of burning at least a transformer. If you experience problems with your current card, save yourself the effort and replace it, you will not regret it. I also produced the TEU-1 receiver board for KD200 and L100. Check out my other ad if you have bisogno.Scheda PCB fully assembled for tone control (low and high) of Seeburg K(D)200 and L100. Complete with 2 6L6 Valves and 1 12Ax7- without connector Perfect reproduction of this circuit printed for Seeburg K(D)200 and L100 TCU-1 (volume, bass, high). Made of high quality heat resistant epoxy resin. This PCB is configured to use standard switches (available separately) to avoid contact problems.